Icosahedron Sonobe (Design by Tomoko Fuse)

Icosahedron Sonobe

I’m back to folding this summer, and I started out with a modular design from our favorite – Tomoko Fuse. Her designs are always interesting and with the right color combinations in paper, one can fold pretty kusudama.

For this particular design, it takes about 3 hours to fold and assemble at moderate pace. The individual units themselves are quite easy to fold, so its a good model to fold for folders with a little experience in folding, too.

Paper to use:
I used regular Kami paper, each of the sheets measuring 3 inches in size. These were 30 square sheets in all and single side colored. One has to start with the white side down in order to have the white color appear in between like shown in the image accompanying this post.

How to Fold the Icosahedron Sonobe:
There are many instructional videos on youtube for this model and the one I referred to and found very helpful is Tadashimori’s Instructional video. His explanations are clear and steps shown are very simple to follow.

Hope you enjoy folding this model!

Icosahedron (Design by Richard Sweeney)

Icosahedron
Icosahedron

This is a modular design I came across on the Internet recently which is not really Origami but is nonetheless very pretty. It follows the same principle of putting together units to form a modular model but the similarity with Origami ends here. This model requires the use of scissors and glue and patience, of course.

The blog, Jeweled Platypus, has a post dedicated to this pretty model and I was quite taken with the photographs of the model. It makes use of commonly found printer paper and there is also a ready-made template which is available on this said post.

Instructions to make this model:
The blog post also details out the instructions to fold this model and the number of units (20 units) required. 10 copies of the PDF template are required, with each sheet having cut outs of 2 units. I am pasting an excerpt of the instructions from the said post here for your easy reference:

If you’d like to make your own icosahedron (the more elaborate one of those two), download this template (PDF) and print out ten copies of it. Here is what you do:

1. Cut out one figure along the bold lines.

2. Score all its curved dotted lines with a dead ballpoint pen or the tip of a lead-less mechanical pencil or something like that. Fold the tabs back and forth to make sure they’re flexible. Pinch gently along the scored curves to begin to form the curved module shape, with the dashes on the inside.

3. Apply white glue or a glue stick to one of the module’s small tabs and connect it to its neighboring bit of paper.

4. Repeat steps 1-3 for the rest of the modules (twenty modules in total).

5. Glue modules together on the large tabs. Be sure to have five modules around each corner, i.e. flowers always have five petals. When you have a few modules together, you can insert a pencil or straightened paperclip through the holes to push tabs with glue together to make sure they stick.

I think this model looks really pretty and will make a wonderful hanging in the home! One can try folding this model in colored paper using the template cut outs as a stencil to make the units.